Add gConfigBleScanCoexPolicy which can be used to
control performance of ble scan case.
’0’ to place more emphasis on BLE Scan results
‘1’ to place more emphasis on WLAN performance
Change-Id: I46c735d8695523d14f6372bc5e47d1d1f51589ae
CRs-Fixed: 2935051
Add ini to set init chain mode for BTC, default value should
be set to the same as macro WLAN_COEX_BTC_CHAIN_MODE_UNSETTLED
that means no need to send init chain mode for BTC to firmware
in wma_vdev_pre_start() process.
Change-Id: I3051a7f8a0c708c7df40d1b95b46e0bfa6892f6c
CRs-Fixed: 2837173
Because newest firmware codes already been changed, the previous
coex configure command are invalid. Firmware need host driver
to enable WMI_SERVICE_THREE_WAY_COEX_CONFIG_LEGACY service during
wlan init. Add a new parameter "gThreeWayCoexConfigLegacyEnable" to
initial config file. If this parameter value is zero,set coex
priorities command will return error.
Change-Id: Ief1617e2ba5363e276c55135198613a0e54b71d5
CRs-Fixed: 2482734
Add ini gBtScoAllowWlan2GScan to support BT SCO-WLAN coex.
Using this ini can control whether allow wlan 2g scan or not
when BT SCO connection is on.
Change-Id: Ia63b1ff92e75937487827c34bca1d2e1c289962d
CRs-Fixed: 2464679
Due to PTA master limitation, zigbee joining network success rate
is low while wlan is working. Wlan host driver need to configure
some parameters including Zigbee state and specific WLAN period to
enhance PTA master. This mechanism is called MPTA helper. The INI
parameter gMPTAHelperEnable is used to enable/disable this feature.
Change-Id: I070c06a00ec2c405540cc40251f5cb7fec211cbd
CRs-Fixed: 2407801
