Drop references to A5 within the debugfs entries so that they
may be reused with other processors.
CRs-Fixed: 2722486
Change-Id: I2680a98dd3d38906e616712da3d6e2835ebb9a85
Signed-off-by: Fernando Pacheco <fpacheco@codeaurora.org>
The HFI interface registers will have a different base address
on the LX7 processor. We can utilize the newly added HFI ops to
abstract the calculation of the address by kicking that info out
to the device interface. The HFI register definitions have been
tweaked to support offsets based on the calculated addresses.
CRs-Fixed: 2722486
Change-Id: I93b9b2827ec0820eaac6ee2e6a611363b96a3223
Signed-off-by: Fernando Pacheco <fpacheco@codeaurora.org>
The steps to enable and send interrupts will differ between processors.
Pull this logic out of the HFI and out to the devices, so that we can
adapt to the specific irq management of any processor.
CRs-Fixed: 2722486
Change-Id: I2a889b91ec13295aa14bb2b16252332482a1225a
Signed-off-by: Fernando Pacheco <fpacheco@codeaurora.org>
The LX7 processor will require a new mechanism to resume/collapse.
Make the current mechanism transparent to the ICP HW manager in
preparation for the new proc. By going through the hw_ops we let
the device interface decide which mechanism to use.
CRs-Fixed: 2722486
Change-Id: I719314b3f505270a33892cb247082e43dad2e92d
Signed-off-by: Fernando Pacheco <fpacheco@codeaurora.org>
The extra read seems to have been added due to an incorrect use
of readw_poll_timeout. The readw_poll_timeout was effectively acting
as a long delay before attempting the second read. Replacing the readw
with a readl results in correctly polling the register. We can safely
remove the extra read and simplify the polling logic.
CRs-Fixed: 2722486
Change-Id: I07269d601e64059ce7654563c379b5dc956895b3
Signed-off-by: Fernando Pacheco <fpacheco@codeaurora.org>
msm: camera: tfe: Fix variable initialization issues
msm: camera: isp: Dual tfe event check with proper hw idx
msm: camera: smmu: Add support for non-contiguous mermory region
msm: camera: smmu: Use iommu best match algo for camera
msm: camera: ope: Optimize allocation of IO configuration
msm: camera: ope: Fix for KW Issues
msm: camera: ope: Add support for stripe level height configuration
msm: camera: tfe: Enable the delay line clc
msm: camera: ope: Fix false alarm for OPE HW timeout
msm: camera: tfe: Support register dump per request
msm: camera: ope: Increase max number of stripes
msm: camera: ope: Change packer and unpacker format in case NV12
msm: camera: tfe: Add packet code get command for tfe
msm: camera: ope: Trigger recovery in case of violation on write bus
msm: camera: ope: Protect ope hw reset with mutex
msm: camera: ope: Add a check for valid request in cdm callback
msm: camera: ope: Remove the BW & clock vote in release context
msm: camera: ope: Reduce OPE BUS memory
msm: camera: ope: Fix return value for ope acquire
msm: camera: ope: Fix false alarm for OPE request timeout
msm: camera: ope: Avoid deadlock during recovery after HW hang
msm: camera: tfe: tfe debug enhancement
msm: camera: cdm: Fix irq_data value in case of inline irq
msm: camera: flash: Switch off flash on provider crash
msm: camera: ope: Initialize ope hw mutex structure
msm: camera: cdm: Flush all available FIFOs during reset
msm: camera: cpas: Add mandatory bw option for axi ports clocks
msm: camera: ope: Use vzalloc to allocate the write bus ctx structure
msm: camera: ope: Fix handling of init hw failure
msm: camera: tfe: Enable per frame register dump for rdi only context
msm: camera: cdm: Protect cdm core status bits with mutex
msm: camera: cdm: correct the error check in cmd submit irq
msm: camera: ope: Fix unclock access during HW reset
msm: camera: ope: Program frame level settings after idle event
msm: camera: ope: Delay releasing of resources for last context
msm: camera: isp: Increase default SOF freeze timeout
msm: camera: smmu: Add map and unmap monitor
msm: camera: isp: Add trace events across ISP
msm: camera: smmu: Profile time taken for map, unmap
msm: camera: ope: Start context timer on receiving new request
msm: camera: tfe: Reduce stack size during set axi bw
msm: camera: cdm: Check for HW state before dumping registers
msm: camera: ope: Reduce stack footprint during acquire
msm: camera: tfe: Disable clock if tfe2 is not supported
msm: camera: cdm: Avoid cdm pause incase of BL submit
msm: camera: tfe: Optimize CSID IRQ logging
msm: camera: ope: Move request id validity check outside of lock
msm: camera: tfe: Correct the tfe hw manager dump logic
msm: camera: ope: Synchronize flush and submit BLs
msm: camera: cdm: Protect cdm reset status
msm: camera: cdm: Handle cdm deinit sequence properly
msm: camera: tfe: Reduce reset timeout to 100ms
msm: camera: ope: Fix hang detection
msm: camera: ope: Make non-fatal logs as debug and info logs
msm: camera: tfe: set overflow pending bit to zero after HW reset
msm: camera: ope: Do not disable CDM during error handling
msm: camera: ope: Add support for OPE Replay
msm: camera: ope: Stop OPE in case of init failure
msm: camera: ope: Synchronize process cmd and flush request
msm: camera: cdm: Fix CDM IRQ handling
msm: camera: tfe: LDAR dump for TFE
msm: camera: ope: Fix the length check for debug buffer
msm: camera: cdm: Fix CDM reset logic
msm: camera: ope: Dump debug registers in case of HW hang
msm: camera: tfe: Support the RDI bus port for line based mode
msm: camera: cdm: Handle out of order reset done events
msm: camera: ope: Consider other contexts during timeout
msm: camera: ope: Put GenIRQ in last stripe BL
msm: camera: tfe: Process the rdi interrupts for rdi only resource
msm: camera: jpeg: Check the HW state before accessing register
msm: camera: csiphy: Update csiphy power-up sequence for lito v2
msm: camera: cdm: Secure freeing of request lists using locks
msm: camera: cpas: Add support for Scuba camnoc
msm: camera: csiphy: Clear secure phy flags on release
msm: camera: tfe: validate the tfe bw num paths
msm: camera: ope: Reorder the reset order in ope acquire
msm: camera: ope: Dump debug registers in case of reset failure
msm: camera: ope: Add logic to detect hang in CDM
msm: camera: isp: Increase max count of cfg to support more init packets
msm: camera: core: Fix cpas axi clk rate overflow.
CRs-Fixed: 2668666
Change-Id: I882ca4bd117bebc7d1c62bc82299d69d7b5c9388
Signed-off-by: Trishansh Bhardwaj <tbhardwa@codeaurora.org>
Add support to discard a memory region inside the full dma map
virtual address space region.
CRs-Fixed: 2580128
Change-Id: I76cc778f2437a01a4efabec836ce92c47d983d61
Signed-off-by: Pavan Kumar Chilamkurthi <pchilamk@codeaurora.org>
Remove soc_info from icp driver as it was unused.
CRs-Fixed: 2557184
Change-Id: I7b85768502f825753ea4b9650b5c3f9df67643fb
Signed-off-by: Karthik Jayakumar <kjayakum@codeaurora.org>
Correct some Makefiles and drivers header inclusion.
Change-Id: Iec3e6e0333ae55e8f1cff9780723e0dad954ff83
Signed-off-by: Jigarkumar Zala <jzala@codeaurora.org>
Bring over camera driver changes as of msm-4.19
commit 5a5551a7 (Merge "msm: camera: reqmgr: Fix CRM
shift one req issue").
Change-Id: Ic0c2b2d74d1b3470c1c51d98228e312fb13c501a
Signed-off-by: Jigarkumar Zala <jzala@codeaurora.org>
