qcacld-3.0: Wait for RSO stop response from firmware

Firmware doesn't expect any vdev commands from host while RSO stop
is happening. It sends a response to the RSO_STOP command once
it's done with cleanup. Host needs to run a timer after sending
RSO stop command to firmware and wait for a maximum of 6 seconds
for the response. Host can stop the timer and allow the commands
to firmware in the below cases,
1. RSO_STOP response with success status
2. RSO_STOP response with HO_FAIL status followed by
   HO_FAIL event: Host needs to wait till HO_FAIL event is received

If firmware doesn't send any response in the 6 seconds wait, issue
a recovery to help to check the firmware state.

Also, set WMI_ROAM_SCAN_MODE_FLAG_REPORT_STATUS always when MLO is
supported while sending RSO_STOP to firmware. It's sent only
in case of wpa_supplicant disabled roaming currently.

Change-Id: I8182e60beb9288dba23cc72e978dc781c8ab1707
CRs-Fixed: 3106023

components/mlme/core/src/wlan_mlme_vdev_mgr_interface.c

@@ -1920,6 +1920,7 @@ static struct mlme_ext_ops ext_ops = {
 #ifdef WLAN_FEATURE_DYNAMIC_MAC_ADDR_UPDATE
 	.mlme_vdev_send_set_mac_addr = vdevmgr_mlme_vdev_send_set_mac_addr,
 #endif
+	.mlme_cm_ext_rso_stop_cb = cm_send_rso_stop,
 };
 
 #ifdef WLAN_FEATURE_11BE_MLO