Merge remote-tracking branch 'quic/display-kernel.lnx.5.10' into display-kernel.lnx.5.15

* quic/display-kernel.lnx.5.10:
  disp: msm: sde: avoid error during fal10_veto override enablement
  disp: msm: update copyright description
  disp: msm: sde: configure dest_scaler op_mode for two independent displays
  disp: msm: dp: updated copyright set for 4nm target
  Revert "disp: msm: sde: consider max of actual and default prefill lines"
  disp: msm: sde: Reset backlight scale when HWC is stopped
  disp: msm: dp: avoid duplicate read of link status
  disp: msm: dsi: update vreg_ctrl settings for cape
  disp: msm: fail commit if drm_gem_obj was found attached to a sec CB
  disp: msm: dp: updated register values for 4nm target
  disp: msm: sde: update framedata event handling
  disp: msm: dsi: Add new phy comaptible string for cape
  disp: msm: sde: software override for fal10 in cwb enable
  disp: msm: update cleanup during bind failure in msm_drm_component_init
  disp: msm: sde: dump user input_fence info on spec fence timeout
  disp: msm: sde: add null pointer check for encoder current master
  disp: msm: dsi: enable DMA start window scheduling for broadcast commands
  disp: msm: sde: avoid alignment checks for linear formats
  disp: msm: reset thread priority work on every new run
  disp: msm: sde: send power on event for cont. splash
  disp: msm: sde: always set CTL_x_UIDLE_ACTIVE register to "1"
  disp: msm: use vzalloc for large allocations
  disp: msm: sde: Add support to limit DSC size to 10k
  disp: msm: sde: add tx wait during DMS for sim panel
  disp: msm: dsi: add check for any queued DSI CMDs before clock force update
  disp: msm: sde: correct pp block allocation during dcwb dither programming
  disp: msm: sde: avoid setting of max vblank count
  disp: msm: sde: add cached lut flag in sde plane
  disp: msm: sde: avoid use after free in msm_lastclose
  disp: msm: sde: update TEAR_SYNC_WRCOUNT register before vsync counter
  disp: msm: dsi: Support uncompressed rgb101010 format
  disp: msm: sde: update idle_pc_enabled flag for all encoders
  disp: msm: sde: flush esd work before disabling the encoder
  disp: msm: sde: allow qsync update along with modeset
  disp: msm: dp: avoid dp sw reset on disconnect path
  disp: msm: sde: consider max of actual and default prefill lines
  disp: msm: ensure vbif debugbus not in use is disabled
  disp: msm: sde: update cached encoder mask if required
  disp: msm: sde: while timing engine enabling poll for active region
  disp: msm: enable cache flag for dumb buffer
  disp: msm: sde: disable ot limit for cwb
  disp: msm: sde: avoid race condition at vm release
  disp: msm: dsi: set qsync min fps list length to zero
  disp: msm: sde: reset mixers in crtc when ctl datapath switches
  disp: msm: sde: update vm state atomic check for non-primary usecases
  disp: msm: sde: reset CTL_UIDLE_ACTIVE register only if uidle is disabled

Change-Id: If480e7f33743eb4788549f853ba05e744ecb38d3
Signed-off-by: Narendra Muppalla <quic_nmuppall@quicinc.com>

msm/sde/sde_hw_catalog.c

@@ -3195,6 +3195,8 @@ static int sde_dsc_parse_dt(struct device_node *np,
 						&dsc->features);
 			if (SDE_HW_MAJOR(sde_cfg->hw_rev) >= SDE_HW_MAJOR(SDE_HW_VER_900))
 				set_bit(SDE_DSC_4HS, &dsc->features);
+			if (sde_cfg->has_reduced_ob_max)
+				set_bit(SDE_DSC_REDUCED_OB_MAX, &dsc->features);
 		} else {
 			set_bit(SDE_DSC_HW_REV_1_1, &dsc->features);
 		}
@@ -5094,6 +5096,7 @@ static int _sde_hardware_pre_caps(struct sde_mdss_cfg *sde_cfg, uint32_t hw_rev)
 		set_bit(SDE_FEATURE_CWB_CROP, sde_cfg->features);
 		set_bit(SDE_FEATURE_QSYNC, sde_cfg->features);
 		sde_cfg->perf.min_prefill_lines = 40;
+		sde_cfg->has_reduced_ob_max = true;
 		sde_cfg->vbif_qos_nlvl = 8;
 		sde_cfg->ts_prefill_rev = 2;
 		sde_cfg->ctl_rev = SDE_CTL_CFG_VERSION_1_0_0;