qcacld-3.0: Use proper API to calculate opclass in OCI frame

Operating class is not calculated properly due to which bandwidth
is getting mismatched in OCI frame.
Because of this ref sta is getting disconnected with SAP.

Replace wlan_reg_dmn_get_opclass_from_channel() with
lim_op_class_from_bandwidth() to calculate opclass.

Change-Id: Ic1d7e59692362130bf1b8205585b5ecd182d4dff
CRs-Fixed: 2806146

core/mac/src/pe/lim/lim_send_management_frames.c

@@ -5116,14 +5116,28 @@ static void
 lim_fill_oci_params(struct mac_context *mac, struct pe_session *session,
 		    tDot11fIEoci *oci)
 {
-	uint8_t country_code[CDS_COUNTRY_CODE_LEN + 1];
+	uint8_t ch_offset;
 	uint8_t prim_ch_num = wlan_reg_freq_to_chan(mac->pdev,
 						    session->curr_op_freq);
-
-	wlan_reg_read_current_country(mac->psoc, country_code);
-	oci->op_class = wlan_reg_dmn_get_opclass_from_channel(country_code,
-							     prim_ch_num,
-							     session->ch_width);
+	if (session->ch_width == CH_WIDTH_80MHZ) {
+		ch_offset = BW80;
+	} else {
+		switch (session->htSecondaryChannelOffset) {
+		case PHY_DOUBLE_CHANNEL_HIGH_PRIMARY:
+			ch_offset = BW40_HIGH_PRIMARY;
+			break;
+		case PHY_DOUBLE_CHANNEL_LOW_PRIMARY:
+			ch_offset = BW40_LOW_PRIMARY;
+			break;
+		default:
+			ch_offset = BW20;
+			break;
+		}
+	}
+	oci->op_class = lim_op_class_from_bandwidth(mac,
+						    session->curr_op_freq,
+						    session->ch_width,
+						    ch_offset);
 	oci->prim_ch_num = prim_ch_num;
 	oci->freq_seg_1_ch_num = session->ch_center_freq_seg1;
 	oci->present = 1;